georgetown university application essays need based scholarships essay dissertation on school principal leadership write an essay buy this in for 125 personal statement university application literary analysis essay the cask of amontillado information system research paper
Skip to main content

High-speed 3D-surface scanning by Area Confocal Scanning Microscopy (ACSM)

Ref-Nr: TA-18/034TLB


The new area confocal scanning microscopy (ACMS) is uniquely suited to optical non-contact measurements such as surface inspection and 3D measurement technology. Compared to customary measuring systems the scanning speed is increased by a factor of several hundred with only a slight reduction in resolution.


Conventionally confocal microscopes obtain 3D images by scanning single points of sample successively and then assimilating the detected signals. A sequence of slices supplies a z-stack i.e. depth-data for the 3D image.

Currently the two predominant methods to increase scan rates are slit scanning microscopy and programmable array microscopy. Both methods reduce the scanning period by passing the beam over the focal plane in only one direction.

Slit scanning microscopes use a slit illumination source to repeatedly sweep the sample in a bar or line and detect the signals through a slit aperture.

Programmable array microscopes on the other hand use MEMS (micro-electro-mechanical systems) technology to illuminate the object through an array of pinholes that produce illuminated points on the surface of the sample. The object is scanned using this array to collect the necessary data for imaging.

Instead of additional scanning in z-direction (axial dir­ection) either technology can be augmented by chromatic confocal microscopy, which uses the fact, that light with different wavelengths has different focal planes along the z-axis to determine the height of the object.

Bilder & Videos


Unfortunately the mechanical scanning only being one-dimensional adversely influences the speed of the 3D-imaging process in either case.


The invention combines the advantages of chromatic con­focal microscopy and a new procedure for a 2D surface scan to allow for area scanning.

Using a slit scanning microscope the applied changes are as follows: The focal plane field is tilted by an angle of e.g. 65 ° to 85 ° for a microscope with a numerical aper­ture of 0.33. Thus, measured peak intensity occurs that is several times wider than a conventional confocal peak. Though the resolution is slightly reduced as a con­sequence, the scanning speed is greatly increased.

A prototype and numerical calculations are available to demonstrate the advantages compared to the state of the art. Since the effect can be simulated, the benefits can be calculated for different microscopy systems.


  • Area scan with a modified confocal microscope setup
  • Scanning speed increases by a factor of several hundred
  • The axial uncertainty is only increased by a factor of approximately 2.5
  • The lateral resolution is only slightly reduced


  • Surface inspection
  • 3D measurement technology


TLB GmbH manages inventions until they are marketable and offers companies opportunities for license and collab­oration agreements.

Technologie-Lizenz-Büro (TLB) der Baden-Württembergischen Hochschulen GmbH

Dipl.-Ing. Julia Mündel
+ 49 721 790 040
Ettlinger Straße 25
76137 Karlsruhe




  • EP 3637167 A1 anhängig
  • US 2020/0116988 A1 anhängig


area confocal scanning microscopy, slit scanning microscope, high-speed, 3D

Kontakt | Geschäftsstelle

TransferAllianz e. V.
Christiane Bach-Kaienburg

c/o TransMIT GmbH
Kerkrader Straße 3
D-35394 Gießen