Skip to main content

Anemometers to Measure Microturbulences


Abstract

Laser cantilever anemometer (LCA) utilizes the laser pointer principle of a scanning-force microscope to capture the velocity and the angle of fluid flows.

 


Background

Turbulences play an important part in many areas of daily life, for example, in combustion and mixing processes, in air tunnels or weather forecasts. However, an analytical approach is hardy possible because of the strong spatial and temporal irregularity of turbulent flows. Instead, many estimations and calculations are based on statistical values which are determined experimentally. A particular challenge consists in the measurement of micro turbulences (<1mm) which is currently done by means of hot-wire anemometry. This type of anemometry uses two crossed, electric-heated wires and determines, from the heat lost, the flow angle and the velocity of a fluid. Hot-wire anemometry has two known drawbacks, such as its small angle resolution and a limited angle range. Limiting is also the regular subsequent recalibration of the measuring sensor. 


Images & Videos


Problem

 

 


Solution

Researchers from the University of Oldenburg, Germany, developed a laser cantilever anemometer (LCA) which utilizes the laser pointer principle of a scanning-force microscope to capture the velocity and the angle of fluid flows. To this end, a cantilever (bending beam) is set into the flow and focused with a laser. The deflection of the laser beam depends on the deformation  of the cantilever which, in turn, is caused by the fluid particles set in motion. So far, cantilevers with a rectangular inflow cross-section have been used. In the  current development,  the tip of the cantilever is additionally structured, which has resulted in a distinctly improved angular resolution. The measuring principle enables measurements in problematical areas, for example, in fluids, near walls or in flows containing particles. The invention is in a  state of application readiness and can be connected to a computer using a USB port for signal evaluation. 


Advantages

The LCA provides a spatial resolution of only 150µm and enables measurements in an angular range of 180 degrees. Scanning of the signal proceeds between 60 and 100kHz. Fluid velocities of 1m/s and more can be very accurately measured, whereby the accuracy will even increase with increasing velocities. The system works robust and without recalibration and is clearly less expensive than any commercially available hot-wire system. The presented anemometer addresses the application field of hot-wire anemometers: instationary effects (flow separation), aeroacustic effects, boundary effects and measurements of turbulence degrees. Due to its robustness and long service life it is also useful to (remote) long-term measurements. 


Scope of application

Aerodynamic and hydrodynamic optimization: aerospace industry, shipbuilding, automobile industry, wind power 


InnoWi GmbH

Tatjana Döring
0421 96007-19
tatjana.doering@innowi.de
www.innowi.de
Address
Fahrenheitstraße 1
28359 Bremen



Development status

Prototype


Patent situation

  • DE 10 2015 000064 B3 granted
  • PCT EP2016/050457 pending

Keywords

Microturbulence, laser cantilever anemometer

Offer at Providers website


Contact | Main Office

TransferAllianz e. V.
Christiane Bach-Kaienburg
(Managing Director)

c/o PROvendis GmbH
Schloßstr. 11-15
D-45468 Mülheim an der Ruhr